Incl. GST·Free standard post on orders over $700
- In store:
- In stock at supplier, allow 5+ days
- Special order, allow 5+ days
- Out of stock at supplier, enquire with store
Available now instead
The Redding Form & Trim Die 350 Rem Mag is out of stock at every supplier we deal with. These are in stock or available to order now.
- Licensed NSW firearms dealer 413159984
- Returns & warranty
- Ask an expert (02) 9882 2689
The Redding Form & Trim Die for 350 Remington Magnum lets you file-trim cases to length in the press, without a case-trimming lathe. It is also used as part of the case-forming process when making 350 Remington Magnum brass from a parent case.
Redding lists it for use with a #6 shellholder in its die charts.
Fits
- 350 Remington Magnum cases
- Listed by Redding as the Form & Trim step for forming 350 Remington Magnum from 338 Winchester Magnum, and as the first step when forming 6.5 mm Remington Magnum from 7mm Remington Magnum or 338 Winchester Magnum.
Redding notes that extended shellholders are required when trimming short cases (under 1.500 in / 38.1 mm overall) and that full-length resizing is required after case forming.
Check the calibre and part number against your die set or press before ordering.
Key Features
- Trim to length in the press – screw the case into the die and file the excess flush with the die top for a consistent case length.
- Part of a forming kit – used after Redding forming dies to finish brass formed from a different parent case.
- Calibre-specific – made for 350 Remington Magnum only, so the trim length matches the cartridge.
- Standard press thread – a 7/8-14 die body that fits standard single-stage reloading presses.
Specifications
| Brand | Redding |
| Part number | 83266R |
| Manufacturer part no. | 83266 |
| Calibre | 350 Remington Magnum |
| Die type | Form & Trim die |
| Shellholder (Redding) | #6 |
| Thread | 7/8-14 |
