Incl. GST·Free standard post on orders over $700
- In store:
- In stock at supplier, allow 5+ days
- Special order, allow 5+ days
- Out of stock at supplier, enquire with store
Available now instead
The Redding Form & Trim Die 256 Win Mag is out of stock at every supplier we deal with. These are in stock or available to order now.
- Licensed NSW firearms dealer 413159984
- Returns & warranty
- Ask an expert (02) 9882 2689
The Redding Form & Trim Die for 256 Winchester Magnum lets you file-trim cases to length in the press, without a case-trimming lathe. It is also used as part of the case-forming process when making 256 Winchester Magnum brass from a parent case.
Redding lists it for use with a #12 shellholder in its die charts.
Fits
- 256 Winchester Magnum cases
- Listed by Redding in its 256 Winchester Magnum from 357 Magnum forming sequence: Form #1 (90233), Form #2 (94233), then this Form & Trim die, with a #12E extended shellholder.
Redding notes that extended shellholders are required when trimming short cases (under 1.500 in / 38.1 mm overall) and that full-length resizing is required after case forming.
Check the calibre and part number against your die set or press before ordering.
Key Features
- Trim to length in the press – screw the case into the die and file the excess flush with the die top for a consistent case length.
- Part of a forming kit – used after Redding forming dies to finish brass formed from a different parent case.
- Calibre-specific – made for 256 Winchester Magnum only, so the trim length matches the cartridge.
- Standard press thread – a 7/8-14 die body that fits standard single-stage reloading presses.
Specifications
| Brand | Redding |
| Part number | 83233 |
| Calibre | 256 Winchester Magnum |
| Die type | Form & Trim die |
| Shellholder (Redding) | #12 |
| Thread | 7/8-14 |
